Installing Manual Caravan Steps - Brackets, Fasteners and Setup

Manual steps are straightforward to install with the correct brackets and fasteners. Work methodically and check movement through the full arc.

Tools and Hardware

• Socket set, spanners, drill and bits
• Suitable bolts, washers, nyloc nuts or threadlock
• Anti-rust primer/paint for new holes

Install Steps

1. Dry fit - hold the folded step in place to confirm position and clearances.
2. Mark and drill - use existing reinforced points or fit backing plates where needed.
3. Bolt up - tighten evenly; do not crush thin sections.
4. Cycle test - deploy and stow several times; confirm no fouling on skirts or wiring.
5. Finish - seal exposed metal and check fastener torque after first trip.

Safety Checks

• Non-slip treads secure and clean.
• No sharp edges near stepping path.
• Step locks positively in stowed position.

Bottom line
A clean, square install prevents binding and rattles. Re-check fixings after corrugations.

Shop manual caravan steps